Glycerin Pump
The main problem when choosing a glycerin pump is that the glycerin solution is a viscous medium, and the viscosity varies greatly depending on temperature.
- if t°<+15°С, then the effectivity of impeller and membrane pumps is reduced, which will lead to the timely increasing of the parts wear because of the increased load, and is not cost-effective solution. At this temperature, only a gear or screw pump is suitable.
- if t° is from +15°С to +60°С, the use of an impeller, diaphragm or gear pump will be a cost-effective solution.
- if t°>+60°С, then any centrifugal pump can be used.
Pump Notes: Cast iron construction is satisfactory. Elastomers should preferably be selected from buna n rubber. The flow part can be made of any corrosion-resistant material, but if there are requirements for maintaining the hygienic purity of the product, it is recommended to use pumps made of stainless steel or polymers.
Sort by:
Sale
13936_22__CAR/SIC__EPDM__304__G60
Mechanical seal R-MG1 22, CAR/SIC, EPDM, 304, G60
14556_12__SIC/SIC__EPDM__304
Mechanical seal for Grundfos R-706H (CR) 12, SIC/SIC, EPDM, 304
